Combined Smoke & Carbon Monoxide Alarm – A single unit can be installed where previously, two were needed. Reduces installation time and protects against both fire and carbon monoxide dangers.
AA Front-Loading Battery Backup – Change batteries without the need to remove the unit from the ceiling, providing continuous protection in the case of a power outage.
Voice Warning - Warns of hazard by announcing “Fire!” or “Warning, Carbon Monoxide.”
Tamper Resistant – Unit will lock to mounting bracket to deter theft or tampering.
Alarm Memory: The green LED will flash every second during alarm. When the alarm condition goes away, the originating alarm unit will flash the green LED every 16 seconds until the Test / Reset button is pressed, thus resetting the alarm.
Peak Level Memory – Announces “CARBON MONOXIDE PREVIOUSLY DETECTED” if alarm has detected a CO level of 100ppm or higher since it was last reset.
Hush™ Feature – Silences nuisance alarms for approximately 9 minutes.
AC-Wire with battery backup Powered by home's electricity in order to provide continuous protection. An included 9V battery protects during short-term power outages.
Front-Loading Battery Speeds up replacement by eliminating the need to remove the unit from the ceiling or wall.
Unique Battery Door Design Will not close if battery is not installed properly.
Voice Warning Supplements warning from the traditional 85-decibel alarm by clearly stating the danger present, fire or carbon monoxide.
PhotoelectricSmokeSensor May detect visible fire particles associated with slow smoldering fires sooner than an ionization sensor.
ElectrochemicalCO Sensor Provides accurate and continual CO protection during the product™s life, remains stable during temperature and humidity changes and resists reactions to household gases that may cause false readings or reduce sensitivity.
SmartTouchButton One button performs the following functions:
Activates the Hush® feature to temporarily silence nuisance alarms (will announce Hush mode activated, or Hush mode cancelled.)
Simultaneously tests the unit's electronics and verifies proper operation
Activates the peak level memory feature (will announce CO previously detected if unit has detected levels of 100 ppm or higher)
Resets the unit during a CO alarm (Unit will re-enter alarm within 6 minutes of reset if 70ppm or more of CO is present).
Silences a low battery chirp for up to 12 hours
Silences the end of life chirp for two days
Tamper Resistant Unit will lock to mounting bracket and battery door will lock to deter theft or tampering.
GreenLED Will flash every 30 seconds to indicate proper operation.
RedLED Flashes in conjunction with the alarm sounding.
End of Life Signal Ten years after initial power, the unit will chirp twice every 30 seconds to indicate the need to immediately replace the alarm.
Low Battery Signal Will chirp every minute and red LED will flash to indicate low battery condition.
Interconnectable Will interconnect with up to 24 other devices (18 of which can be initiating) including smoke, CO and heat alarms.