Carbon Monoxide Alarms

10-Year Sealed Battery Alarms

View as Grid List

Sort by

Display per page

Interconnectable with up to 24 devices (of which 18 can be initiating) including smoke, CO and heat alarms.
9V Battery backup provides protection in case of power failure.
Test / Reset Button tests the unit for proper operation. Resets the carbon monoxide alarm.
Tamper resist to deter battery and alarm theft.

$CAN 67.29

3 AA Battery Operated – Provides continuous protection and flexible installation for areas with no AC outlets.
Test / Reset Button – Tests the unit for proper operation. Resets the carbon monoxide alarm.
CSA Listed

$CAN 44.51

Tamper Resist Feature can be activated to cause unit to go into alarm if it has been unplugged or has come loose from the outlet.
2 AA Battery Backup provides continuous protection even during power outages.
Low Battery Hush silences low battery chirp warning for up to 12 hours in order to maintain protection without having to replace the batteries at an inconvenient time.
Event Memory – If the unit has detected CO concentrations of 100ppm or greater, the green LED will flash every 10 seconds.
Loud 85 Decibel Alarm alerts of deadly CO gas.
Test/Reset Button – Tests the alarm electronics and resets the unit during alarm.
CSA-Listed

$CAN 47.03

10-Year Sealed Lithium Battery eliminates the need to replace the battery. No battery to replace for the life of the alarm (10 years).
Digital Display shows CO level in PPM (parts per million). No buttons to push! Continuous digital readout gives you peace of mind at-a-glance.
Test / Reset Button tests the unit for proper operation and resets the carbon monoxide alarm.
End of Life Notification will emit two beeps every 30 seconds, 10 years after the unit is first powered, to indicate it is time to replace the alarm.
Event Memory will flash a red LED every 60 seconds to alert that a high level of carbon monoxide has been detected within the last 14 days.
CSA-Listed

$CAN 72.41

Digital Display - Displays the level of carbon monoxide the unit is sensing. The unit updates this reading every 15 seconds.
Test/Reset Button -Tests unit™s electronic circuitry and horn and resets the unit during alarm.
Peak Level Button -Displays the peak CO level recorded by the alarm since it was last reset or unplugged.
9V Battery Backup -Provides protection during a power outage.
CSA-Listed

$CAN 67.29

Combined Smoke & Carbon Monoxide Alarm – A single unit can be installed where previously, two were needed. Reduces installation time and protects against both fire and carbon monoxide dangers.
AA Front-Loading Battery Backup – Change batteries without the need to remove the unit from the ceiling, providing continuous protection in the case of a power outage.
Voice Warning - Warns of hazard by announcing “Fire!” or “Warning, Carbon Monoxide.”
Tamper Resistant – Unit will lock to mounting bracket to deter theft or tampering.
Alarm Memory: The green LED will flash every second during alarm. When the alarm condition goes away, the originating alarm unit will flash the green LED every 16 seconds until the Test / Reset button is pressed, thus resetting the alarm.
Peak Level Memory – Announces “CARBON MONOXIDE PREVIOUSLY DETECTED” if alarm has detected a CO level of 100ppm or higher since it was last reset.
Hush™ Feature – Silences nuisance alarms for approximately 9 minutes.
cUL- and CSA-Listed

$CAN 82.41