Combination Alarms

View as Grid List
Sort by
Display per page

Kidde CP9000CA Battery Operated Photoelectric Talking Smoke & Carbon Monoxide Alarm

  • Combined Smoke & Carbon Monoxide Alarm  A single unit can be installed where previously, two were needed. Reduces installation time and protects against both fire and carbon monoxide dangers.
  • 9V Front-Loading Battery Door  Speeds up replacement by eliminating the need to remove the unit from the ceiling or wall.
  • Unique Battery Door Design  Will not close if battery is not installed properly.
  • Voice Warning  Supplements warning from the traditional 85-decibel alarm by clearly stating the danger present, fire or carbon monoxide.
  • Photoelectric Smoke Sensor  May detect visible fire particles associated with slow smoldering fires sooner than an ionization sensor.
  • Hush Feature  Silences nuisance alarms for approximately 9 minutes.
  • Peak Level Memory  Announces CARBON MONOXIDE PREVIOUSLY DETECTED if alarm has detected a CO level of 100ppm or higher since it was last reset.
  • cUL- and CSA-Listed
$CAN 69.81

Kidde 900-0213 Hardwire Talking Photoelectric Smoke & Carbon Monoxide Alarm with Front Load Battery Backup

  • AC-Wire with battery backup Powered by home's electricity in order to provide continuous protection. An included 9V battery protects during short-term power outages.
  • Front-Loading Battery Speeds up replacement by eliminating the need to remove the unit from the ceiling or wall.
  • Unique Battery Door Design Will not close if battery is not installed properly.
  • Voice Warning Supplements warning from the traditional 85-decibel alarm by clearly stating the danger present, fire or carbon monoxide.
  • Photoelectric Smoke Sensor May detect visible fire particles associated with slow smoldering fires sooner than an ionization sensor.
  • Electrochemical CO Sensor Provides accurate and continual CO protection during the product™s life, remains stable during temperature and humidity changes and resists reactions to household gases that may cause false readings or reduce sensitivity.
  • Smart Touch Button One button performs the following functions:
    • Activates the Hush® feature to temporarily silence nuisance alarms (will announce Hush mode activated, or Hush mode cancelled.)
    • Simultaneously tests the unit's electronics and verifies proper operation
    • Activates the peak level memory feature (will announce CO previously detected if unit has detected levels of 100 ppm or higher)
    • Resets the unit during a CO alarm (Unit will re-enter alarm within 6 minutes of reset if 70ppm or more of CO is present).
    • Silences a low battery chirp for up to 12 hours
    • Silences the end of life chirp for two days
  • Tamper Resistant Unit will lock to mounting bracket and battery door will lock to deter theft or tampering.
  • Green LED Will flash every 30 seconds to indicate proper operation.
  • Red LED Flashes in conjunction with the alarm sounding.
  • End of Life Signal Ten years after initial power, the unit will chirp twice every 30 seconds to indicate the need to immediately replace the alarm.
  • Low Battery Signal Will chirp every minute and red LED will flash to indicate low battery condition.
  • Interconnectable Will interconnect with up to 24 other devices (18 of which can be initiating) including smoke, CO and heat alarms.
  • cUL- and CSA-listed
$CAN 86.40